When driving a forklift its forks should be at which of the following heights?

Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground.

How low should the forks generally be when carrying a load?

Travel with forks as low as possible from the floor and tilted back (usually within 10-15 cm (4 to 6 inches) above the floor). Match speed to, load, presence of pedestrians, obstructions, and driving and workplace conditions, including slippery surfaces.

Where should the forks or load be positioned while driving a loaded forklift?

drive with the fork arms as close to the ground as reasonably practicable, with the tips of the fork arms tilted slightly upwards and away from the ground, whether driving with or without a load.

IT IS IMPORTANT:  Frequent question: How do I find out what year my Toyota forklift is?

What is maximum fork height?

Maximum fork height is the distance from the ground to the lifting surface of the forks with the mast fully lifted. A common height is 188 inches or 15’8”. While many fork heights are available, this mast is about as high as you can have and still work in a typical semi-trailer.

Which of the following actions should be taken when driving a forklift?

Always operate the forklift at a speed that will allow you to stop the forklift safely under all travel conditions. Never take part in horseplay while driving a forklift and never take part in stunt driving with a forklift. Slow down while operating on wet or slipper floors.

When travelling forks first Which direction is the counterbalance moving?

Move the direction control away from you, toward the mast, to travel forks first. Move the control toward you, away from the mast, to travel power unit first (forks trailing).

When setting a load What should you do first?

When setting a load, what should you do first?

Place the tasks for lifting a loaf in their proper order.

  1. Level the forks and set the forks for proper width.
  2. Position the load on the forks.
  3. Lift the load straight up.
  4. Tilt the load back slightly.
  5. Back up.

When driving an empty forklift down a ramp in what direction should the forks point?

When going down a ramp, drive in reverse with the load and keep the forks pointed up the slope. When traveling without a load, the forks should always point down the slope. The forklift operator should also drive in reverse up the ramp or drive forward when going down the ramp.

IT IS IMPORTANT:  How much does a full propane tank weigh for a forklift?

Which direction should the load face when traveling up a ramp?

Requirements and Recommended Practices

When traveling with a load, the load should point up the incline, regardless of direction of travel. Going up the incline: Drive forward. Forks pointed upgrade.

How do you move the forks on a forklift?

The fork will be resting in a small groove in the crossbar; nudge the fork out of the notch so that it will slide along the top of the crossbar. If the forks are rarely adjusted they may be very hard to move. If so, move to the end of the fork and move it from side to side to break it free.

What is the height of a forklift?

Most standard forklifts reach heights between 10 to 15 feet, but some can lift as high as 36 feet. Sit-down models are also available in a couple different configurations: 4-wheel and 3-wheel.

What is the standard height of a forklift?

Another measurement to consider is height. Most standard forklifts can reach heights between 10 and 15 ft, but special forklifts like the telehandler can lift as high as 55 ft depending on the telehandler size you select.

What is the height of a forklift mast?

A typical two-stage mast for a forklift with a capacity from 2,000 lbs. to 6,000 lbs. will have approximately 130″ of maximum lift and will be around 83-88″ Overall Height Lowered (OAHL).

Which of the following indicates the proper position of the forks when left unattended?

Proper position is to have the forks tilted toward the ground and lowered. This is to ensure you do not cause a tripping hazard. Never leave them elevated while unattended.

IT IS IMPORTANT:  Does Home Depot rent engine hoists?

What are four precautions you should take prior to leaving a forklift unattended?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

How far should forks enter a pallet?

Carefully slide the forks into the pallet; the forks should be at least two-thirds the length of the load. Distribute the load’s weight evenly between the forks and ensure the load is centered. Tilt the mast to stabilize the load.