Frequent question: Why will a lawn mower not start?

Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.

Why does my mower crank but not start?

The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

What causes a lawn mower to stop working?

The most common cause of a mower failing to keep running is a clogged air filter. Take the cover off the air filter compartment and remove the filter to see if it is dirty, or clogged with oil and dust. … If it is a dirty paper filter, buy a new one; these cannot be cleaned.

How do I know if my lawn mower carburetor is bad?

Dirty Carburetor Symptoms

  1. The lawn mower engine has trouble starting.
  2. The engine starts but stalls while you’re cutting the lawn.
  3. The engine runs rough during mowing.
  4. Black smoke is seen coming out of the muffler.
  5. There is a noticeable increase in fuel consumption during normal lawn mower use.
IT IS IMPORTANT:  You asked: Who is the owner of Bad Boy mowers?

How do you start a choke lawn mower?

Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.

Can old gas cause a lawn mower not to start?

Putting old gasoline into your lawn mower can cause a variety of problems. … Sediment and other deposits can build up in the carburetor and fuel line, making it harder to start your mower, and as the buildup continues, it may prevent the mower from starting at all.

How do you start a lawn mower after winter?

Give the spark plug wire a little tug to see if it’s loose. If it is, push it onto the plug and try starting the mower. If there isn’t any difference, remove the plug with a spark plug wrench and clean the gap with an emory board. If the plug looks worn, replace it with a new one.

How do you start a lawn mower without a primer bulb?

In order to start your mower without a primer, squirt starter fluid directly into the carburetor via the air intake. Simply remove the air filter cover, take out the air filter, and squirt starting fluid into the air intake nozzle. Quickly replace the air filter, and start your mower. It should start straight away.

How do you prime a lawn mower?

How to Prime a Lawnmower Carburetor

  1. Remove the cap from the lawnmower fuel tank. Fill the tank with gasoline and replace the cap.
  2. Locate the primer bulb on the side of the lawnmower engine. …
  3. Press and release the primer bulb three times with your finger to prime the lawnmower carburetor.
IT IS IMPORTANT:  How do I donate a riding lawn mower?

Why does my lawn mower run for a few minutes then stops?

If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. … If your lawnmower starts up but then dies in the middle of mowing your lawn, you could have a bad spark plug. The spark plug works with the ignition coil to create a timed spark in the cylinder, causing combustion.